A 70 mm dust boot for the DeWalt DWP611.
Dast Boot labels this the 70 mm DeWalt 611 option; DeWalt lists the DWP611 motor body at 69 mm. It is intended for that router after its identity, mounting plane, carriage, and hose clearance are confirmed.
Match the body. Then check the machine.
Fit boundary
The 70 mm label is the Dast Boot catalog name, not a claim that DeWalt specifies a 70 mm motor. Regional variants and aftermarket clamps can differ, so confirm the router and make sure the mount does not obstruct the collet lock, controls, or cooling path.
Manufacturer reference: DeWalt support: DWP611 motor diameter is 69 mm ↗
Where this mount starts.
- DeWalt DWP611 router bodies, officially listed at 69 mm, using the 70 mm catalog option
- Original X-Carve configurations that still use the DWP611
- Other CNC carriages using a measured 70 mm circular router body
Four checks before ordering.
- Confirm the router is a DWP611 or directly measure any other circular body before choosing this option.
- Locate a straight mounting section that leaves vents and controls open.
- Check the collet-lock and wrench-access area with the skirt attached and detached.
- Verify the hose clears the X carriage and cable management through the full travel.
Dry-fit the whole work envelope.
A matching diameter is the starting point. Safe travel, cooling, tool access, and hose support still depend on the machine around it.
- 01
Unplug the router and park the machine for safe access.
- 02
Seat the 70 mm mount on the clean cylindrical router body.
- 03
Choose a height that preserves collet access when the magnetic skirt is removed.
- 04
Connect and support the selected hose adapter.
- 05
Check the complete machine envelope at low speed with the spindle powered off.
The same Dast Boot system, sized to your spindle.
The fit option changes the spindle mount. The quick-release clear skirt, rigid inner collar, LED halo, and adaptable hose connection remain the core system.
Explore the complete systemIs the DWP611 body 69 mm or 70 mm?
DeWalt’s support documentation lists the DWP611 motor at 69 mm. Dast Boot identifies the matching shop option as “70 mm DeWalt 611”; confirm the exact router and mounting area before ordering.
Does this fit an original X-Carve?
It is the relevant mount for X-Carve setups that still use the DeWalt DWP611. Upgraded routers, Z carriages, and accessories require a fresh body and clearance check.
Can I reach the bit without removing the whole boot?
The clear skirt assembly attaches magnetically and releases for tool access. Position the upper mount so the detached-skirt opening leaves enough room for your wrench and tooling.
The label follows the measurement.
Choose the mount with confidence.
Confirm the body and clearance first; choose the matching spindle option at checkout.
Configure Dast Boot on Etsy